FUNCTIONAL DESCRIPTION
CONTROLS AND COMPONENTS:
1. 3/8 in. Variable Speed Drill
2. 10mm (3/8 in.) Keyless Chuck
3. Speed Control Adjusting Switch
4. Trigger Switch
AASSSSEEMMBBLLYY
Do not attempt to tighten drill bits (or any other accessory) by gripping the
front of the chuck and turning the tool on. This may cause personal injury
and/or damage to the chuck.
When removing the bit from the tool, avoid contact with skin and use proper
protective gloves when grasping the bit or accessory. Accessories may be hot
after prolonged use.
BIT INSERTION
1. Unplug the drill. Never change bits
on a live drill.
2. Make sure the bit is undamaged,
sharp and free from wood or metal
shavings. Foreign material on the bit
may keep the chuck from tightening
fully. A loose bit may cause injury.
3. Hold the rear end of the chuck in one
hand and use the other hand to rotate
the front end in a clockwise direction
to open the jaws of the chuck.
4. Insert the shank of the bit (or other accessory) fully into the keyless chuck, tak-
ing care to keep the bit in the center of the jaws of the chuck.
5. Turn the front end of the chuck counterclockwise to hold the bit in place.
6. Tighten securely by turning the front end of the chuck counterclockwise while
holding the rear end.
Always run the drill for one minute before drilling to make
sure the bit is properly seated. If the bit needs to be adjusted, unplug the drill
before touching the bit.
OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS
Disconnect the power plug from the AC power source
before any assembly, adjustments, or adding/removing accessories.
Following this preventative step reduces the risk of the drill coming on acciden-
tally and the risk of damage to the workpiece and injury to the operator.
OOPPEERRAATTIINNGG TTHHEE OONN//OOFFFF SSWWIITTCCHH
Squeeze the trigger switch to turn the tool “ON”. Release the trigger switch to turn
the tool “OFF”.
When drilling for extended periods, the “Lock-On” switch may be used, but do not
use this switch in situations where the drill is likely to bind or kickback. If kickback
does occur, the sudden motion of the tool may make it difficult to release the “Lock-
On” switch and turn the drill off.
109
5. Lock-On Switch
6. Forward/ Reversing Switch Lever
7. Power Cord
HOLD HERE
HOLD HERE
RELEASE
GRIP
1
2
6
4
3
5
7
(10 pages)
(23 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals