USING THE PAD SANDER:
1. Prepare the workpiece according
to instructions in this manual.
2. Plug the sander into an approved
power source.
3. Turn on the sander by depressing
the ON/OFF switch on the front.
4. Hold the sander against the work-
piece with a firm grip.
5. Sand the workpiece in a circular
motion. Using a straight in-line
motion can cause uneven patterns
to result.
Do not hold the Pad Sander in one spot for prolonged
periods. This can cause the sander to overheat as well as causing scorching
on the workpiece. Damage to the Pad Sander and workpiece could result.
Always wear approved safety eyewear and appropriate
dust filters or respirators when using this tool.
MAINTENANCE AND CLEANING
CLEANING: To avoid accidents, be sure to disconnect the
tool from the electrical power source before any cleaning or maintenance.
The tool can be cleaned by using compressed dry air. If compressed air is not
available, a soft natural bristle paint brush will work. Always wear safety gog-
gles when cleaning tools with compressed air.
Avoid using certain cleaning agents and solvents.
Chemicals like gasoline, carbon tetrachloride, acetone, paint thinner or ammo-
nia products can damage the plastic parts of the tool.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.
If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may experi-
ence a loss of power, excessive voltage drop or overheating. The smaller the gauge
number, the heavier the cord (see table on next page).
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS
TOOL CURRENT RATING CONDUCTOR SIZE IN A.W.G
AMPERE 10FT. 25FT. 50FT. 100FT.
3-6 18 18 18 18
6-8 18 18 18 16
8-10 18 18 18 14
10-12 16 16 14 14
12-16 14 12 12 -
16-20 12 12 12 -
SPECIFICATIONS
SPECIFICATIONS
Voltage 120V 60 Hz
Rated Current 1.3 A
Diameter of Orbit 1.587mm (1/16")
No-Load Speed 10000/min
OTHER CONSUMER DO-IT-YOURSELF (DIY) TOOLS
Alltrade offers a full range of Kawasaki™ tools that make DIY jobs easy. If you would
like further information on the following products, please contact Alltrade Customer
Service Department at 1-800-590-3723.
Cordless Drills/Screwdrivers
Impact Wrenches
Sanders
Jigsaws
Circular Saws
Angle Grinders
11
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals