Kawasaki 840107 Use and Care Manual

87-1904-60957KAWASAKI™ IS A TRADEMARK LICENSED BY KAWASAKI™MOTORS CORP., U.S.A., WHICH DOES NOT MANUFACTURE OR DISTRIBUTE THIS PRODUCT. CONSUMER INQUI

RECOMMENDED SIZES OF EXTENSION CORDS FOR 120 VOLT AC 60 HZ TOOLSCURRENT RATING IN AMPS CONDUCTOR SIZE IN A.W.G.MORE THAN NOT MORE THAN 25 FT. 50 FT.

the product, it may replace it with a new or reconditioned one of the same or comparable design. The repaired or replaced unit will be warranted under

Limitations on Warranty Disclaimers Some states do not allow limitations on how long an implied warranty lasts and some states do not allow the exclus

ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16SPECIFICATIONS . . . . . . . . . . . . . . . . .

DANGER indicates an imminently hazardous situation which, if not avoided, will result in deathor serious injury.WARNING indicates a potentially hazard

Store idle power tools out of the reach of children and do not allow personsunfamiliar with the power tool or these instructions to operate the powert

Disconnect the plug or remove the battery pack from tool and place the switchin the locked or “OFF” position before making any assembly adjustments,ch

BATTERYBefore using battery pack, please read carefully all instruc-tions and cautionary markings on battery pack, batterycharger and product using ba

REMOVING / ATTACHING BATTERY PACKREMOVE BATTERY PACK:1. Press both release buttons on either side of the Cordless Drill to release the battery pack.2.

OPERATING THE DRILLNever tape the trigger switch down to provide continu-ous high speed. The tool may fail under such conditions causing fire or perso

DRILLING MASONRYWHEN DRILLING MASONRY:• Masonry can be brittle so be careful not to apply too much pressure and crack the material.• Apply enough pres